VC4 Programs in SIMPLĬreate a new SIMPL program, but for the Control Processor select “Ethernet-Only 4-series”: PRO2 says it’s connected (since I already loaded a program to the VC4). We can check the IP table status though: EslavePRO2> IPTABLEĬIP_ID Type Status DevID Port IP Address/SiteNameġ72.20.10.88 is the IP address of my VC4 server. You do this by adding a master IP table entry: PRO2> ADDM DB 172.20.10.88Īfter a reboot, the PRO2 won’t accept new programs. Probably the easiest way to use one just for its physical ports though is to put it into slaved mode. As long as the power supply hasn’t died, these things run great. OK, time to grab a PRO2 for testing! 2-Series I refreshed the VC4 settings page to make sure everything was still communicating. Reboot to make sure all services start up correctly. I just accepted all the default port numbers: Updating from 2.7000 to 4.0000 seems like a big jump… I downloaded the latest software from Crestron and unpacked it: I told them we’d need to keep the PRO2 for all the connectivity, but maybe we could get it to talk to a new program running on VC4? Software Upgradeįirst thing I needed to do was update my VC4 installation to support SIMPL programs. Looking at the existing system, there were a couple devices that needed a hardware controller: DSP and lighting control over RS-232, cable TV control over IR, and a Cresnet button panel for basic room functions. I was recently asked if we could get a customer with an old PRO2 upgraded to VC4, probably to support new hardware they wanted to install.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |